Fully automatic professional microprocessor controlled 6/12/24V charger suitable for all Pb: WET, MF, GEL, AGM, Ca/Ca batteries.
3 Charging modes (1.5 - 3.5 and 7.0 Amp) Suitable for batteries from 8 to 130 Amp. With desulfation function.

The charger is set to the battery voltage at the push of a button. 6, 12 or 24 volts. The maximum charging current is then set (min/med/max). A desulfation program may be run before charging. With this, the charger tries to get (slightly) sulphated batteries back to normal.

Can remain connected to the battery for a long time. Keeps the battery "ready for use".
Good protection, designed to protect vehicle electronics. Spark-free. Protected against reverse polarity and short circuit. The charging voltage is free from interference and voltage peaks. Can be connected directly to the battery, it does not have to be disconnected (DIN 40839 fault class I.) Battery Test for sulphated battery detection and sulphated battery recovery "Desulphation", regenerates batteries that are heavily discharged.

Due to its universal applicability and reliability, this charger is ideal for use in workshops.

Technical data:
Power supply (Volt AC 50-60Hz): 1 Ph x 230
Power: 260W
Nominal battery voltage: 6 - 12 - 24 Volt
Voltage limitation: 7.4 - 14.8 - 29.6 Volt
Average charging current: 1.5 - 3.5 - 7.0 Amp
Effective charging current: 11 Amp. max
Charging functions: 3
Charging programs: 2
Battery types: Pb: WET, MF, GEL, AGM, Ca/Ca
Battery capacity (Ah min/max): 8 / 130